mdadm: command not found

The mdadm command is a tool used to manage software-based RAID arrays. A redundant array of independent disks (RAID) is a set of vendor-independent specifications that support redundancy and fault tolerance for configurations on multiple-device storage systems. In a RAID array, data is stored across multiple physical storage devices, and those devices are combined into a single virtual storage device. This type of software-based RAID configuration is an alternative to using device mapper and DM-Multipath. The mdadm tool enables you to create, manage, and monitor RAID arrays.

mdadm has several modes of operation: Create, Build, Assemble, and Monitor. Each of these modes has its own command-line switch. In addition to these modes, there are many management features that operate independently.

Example usage

Let’s assume you added three disks to your virtual machine. Let’s create a RAID 0 device called /dev/md127 (just a random number that is not yet in use):

$sudo mdadm --create /dev/md127 --level 0 --raid-devices 3 /dev/sd{c,d,e} 

Verify the configuration:

$ cat /proc/mdstat
$ sudo mdadm --detail /dev/md127

Make the configuration persistent:

$ sudo mdadm --detail --scan --verbose >> /etc/mdadm.conf

Now you can use this device and format it with a filesystem. For instance:

$ sudo mkfs.ext4 -L data_mnt /dev/md127

If you encounter below error while running the mdadm command:

you may try installing the below package as per your choice of distribution:

mdadm Command Examples

1. Create an array:

# mdadm --create /dev/md/MyRAID --level raid_level --raid-devices number_of_disks /dev/sdXN

2. Stop array:

# mdadm --stop /dev/md0

3. Mark disk as failed:

# mdadm --fail /dev/md0 /dev/sdXN

4. Remove disk:

# mdadm --remove /dev/md0 /dev/sdXN

5. Add a disk to array:

# mdadm --assemble /dev/md0 /dev/sdXN

6. Show RAID info:

# mdadm --detail /dev/md0